TNAQ420
1/27/2003 12:31:35 AM
JUST RECENTLY GOT VALVE JOB AND HEAD RESURFACED.STARTED ONCE, RAN A COUPLE MINUTES AND DIED NOW WONT START. SOUNDS KINDA LIKE TIMING BUT EVERYTHING IS LINED UP ON THE MARKS.I HEARD SOMETHING ABOUT A CRANK ANGLE SENSOR.DONT KNOW WHERE WHAT OR PURPOSE. ANY CLUE ??? PLEASE HELP!!!
EcLiPsE-101
2/16/2003 3:57:58 AM
ok well spend 50 bucks and get yur car checked out, it would be worth it! thats basically all i can say, check on yru milage, yur trans, engine, and yur starter motor.
w8ing
6/7/2003 8:59:16 AM
I know this post is way late, but I just found this site and thought I could lend a hand if you have not found the problem yet. If you have the 2.0L motor, I would look at the camshaft position sensor. It is located on the right side (if you're sitting in the car) between the head and valve cover. This is if you are absolutely sure the timing is ligned up and the belt has not slipped any.
