[ View Full Version Of This Page ]

How much?

All Forums » 3rd Generation » How much?

Pages: [1] 2
JDMVR43000
7/24/2005 8:27:53 AM
How much boost can the 3rd gen eclipse GT withstand on stock internals? Also approximate horsepower it would be running at maximum(but still reliable)limit?
isimon77
2/24/2008 2:12:16 PM
|----------------------------|

That much
EMonz57
2/24/2008 3:15:32 PM
No more than 8PSI on the stock GT bottom.  no more than 6 on the stock GTS bottom.  and 8 PSI will make around 300WHP
WPSpyderGT01
2/24/2008 11:06:07 PM
quote:

ORIGINAL: EMonz57

No more than 8PSI on the stock GT bottom.  no more than 6 on the stock GTS bottom.  and 8 PSI will make around 300WHP

 
only 300whp if your a 5spd for autos you get around 270's
 
but what mike said is 100% true
PoolhallJunkie777
3/1/2008 12:14:54 AM
I have a GTS and i was planning to boost it this summer, what whould i have to do in order to run around 10 psi?

also if it did work i was going to run 3psi untill i built the engine more, because i am a poor.
Sebba
3/1/2008 12:39:51 PM
Anything past 6 and you need a built mottom end. That includes lower compression ratio pistons, forged rods etc... With all that you could run well over 10... more than double that even. However, thats only what you would need in terms of the motor. Thats not including things like injectors, fuel pump, tuning device, gauges, exhaust, intake ... all that factors into it.
EMonz57
3/1/2008 3:52:22 PM
quote:

ORIGINAL: Sebba

Anything past 6 and you need a built mottom end. That includes lower compression ratio pistons, forged rods etc... With all that you could run well over 10... more than double that even. However, thats only what you would need in terms of the motor. Thats not including things like injectors, fuel pump, tuning device, gauges, exhaust, intake ... all that factors into it.
sebba again not knowing to much about these cars,  I understand you are speaking in general so that is why I am going to agree with you for the most part with the exception that the 6g72 has very strong rods.  they are good to around and over 500HP stock.  Its the pistons that SUCK.  So really just pistons internally will do if you really want to, BUT while your in there you might as well slap in more beef
PoolhallJunkie777
3/1/2008 4:42:21 PM
i dont have the cash to to multiple upgrades in one setting. but in a nut shell new pistons and i should be fine?


also my friend also suggested changing the head gasket and keep the pistons and just run 5 psi untill i get the actual money for it.

suggestions, or is my friend just dumb as rocks.
EMonz57
3/1/2008 5:13:27 PM
well you still need injectors, fuel pump, gauges, emanage ect ect.  you need atleast $3k for turbo these cars and that is a bare minimum only to run 6psi.  Also you can supercharge with RippModds and there kits are pretty well put together and the stage III kit comes with pistons but costs like $6k but will make over 420WHP.
 
The stage I runs 6PSI.  That kit is rather cheap but dont remember the price.
Sebba
3/1/2008 5:16:45 PM
Yeah, I didn't know that Mike.
 
Well, why would you change a perfectly good headgaskets? Honestly changing it isnt going to do you the slightest bit of good. Just cost you more money. Not dumb, just not knowledgable.
 
Well, if the pistons are safe at 6, running 5 isnt going to make the slightest bit of difference. Yes you can run 6psi untill you have the cash to put in a nice set of pistons. Then when you tear the motor down, you will need to change the headgaskets, because you have to remove the heads (you shouldnt clamp them twice). Then you can crank it up.
 
This is just a suggestion, that I tell pretty much everyone. Lets say you get this turbo setup, then you have to worry about tuning, and not to mention your clutch is going to take a beating (unless you are auto). Then once you get all that, you have to worry about traction. Any decent power in a front wheel drive car is going to be a pain. Ask EMonz, he had a turbo 3g.
 
So, what I'm getting at... are you really attached to this car? Have you ever considered buying an already turbo car? They are much easier to mod. Not to mention, one with all wheel drive would hold the power.
EMonz57
3/1/2008 5:41:41 PM
Yea changing headgaskets in the GT and GTS is easier said than done too.  The motor has  heads one in front which will be easy but the one in the back is prob close to impossible without pulling the motor.  If your an auto you will need do some sort of tranny cooler too.  and a 5spd will need a beefy clutch.  like I said this is the bare minimum
Lil Evo
3/1/2008 5:51:52 PM
save yourself the headache of doing a job twice. save your money, do it right the first time. less overall down time for the car, less tuning, headaches of making the difficult parts fit (as opposed to making them fit once, having to take them off six months later, then making them fit again), all this euqals makes for less asprin and more money left in your pocket at the end of the project.
PoolhallJunkie777
3/1/2008 7:41:56 PM
yeah i am pretty attached to my car. i guess i will just start collecting parts until i have everything to start my project.


i got a deal right now with another kid for an emange (older one) for 100 and a 14b for 50. (is this ideal?)


i suppose i will wait untill i get a few more grand.

thanks for the into, i am just excited i suppose and sorta bumed at the same time.
Sebba
3/1/2008 9:38:00 PM
The 14b is useless on the 4G63... I can't imagine how badly it would suck on the 6G73 lol
PoolhallJunkie777
3/1/2008 10:41:29 PM
even for a start?
Sebba
3/1/2008 10:43:09 PM
Yeah dude... its THAT useless.
 
Don't try and piece together your own turbo kit, thats not going to happen.
PoolhallJunkie777
3/1/2008 11:23:29 PM
i could buy two of them for 100, would that do anything?
Sebba
3/2/2008 12:33:26 AM
Yeah that would be better... but a larger single turbo would still be better
EMonz57
3/2/2008 6:48:54 AM
quote:

ORIGINAL: PoolhallJunkie777

i could buy two of them for 100, would that do anything?
no because your not going to be able to TT the car.  Go on club3g.com and search tearston turbo kits.  have a blast.  forget peicing one together.  buy one of those kits if any are for sale
PoolhallJunkie777
3/2/2008 6:33:26 PM
what about the emanage, would i be able to use that still?            and thanks
EMonz57
3/2/2008 6:37:28 PM
you could if you plan to turbo it one day.  But otherwise no
PoolhallJunkie777
3/2/2008 8:42:51 PM
emonz you said that i could get a supercharger instead. i looked that up and i kinda like that idea better.


for one, would that be the better way to go for me since i dont have the budget?
two, what would i have to do in order to support the supercharger, or do you know?
EMonz57
3/3/2008 5:49:15 AM
call RippModds.  they sell these things and have been for like 5 years or more now
WPSpyderGT01
3/9/2008 11:50:31 PM
want some performance parts i have a built engine =D selling it for alot less then i bought it and its never used!
PoolhallJunkie777
3/10/2008 5:50:36 PM
how much and what is on it?

Pages: [1] 2

[ View Full Version Of This Page ]

Return to the Mitsubishi Forum home page - Archive Home