xslim69
4/30/2006 8:08:00 PM
i have a 1997 gst. the problem im having is it wont start. i have tested all the sensers and their ok. i get spark on all 4 but no fuel in to the clienders. i have replaced the ecu,coil packs,fuel filter,plugs,wires. the injectors are not pulsing, but the fuel pump comes on.
could the injestor resistor pack be bad.
slow420a
5/1/2006 8:26:29 AM
Thats possible or you could have a bad cam position sensor.
xslim69
5/1/2006 3:45:46 PM
i just found out today that my 97 gst has a 1g motor in it. the can angle is good. that is one of the many things i tested, it has power and is sending signal to the ecm. this all happened when i upgrated the plugs and wires.
xslim69
5/6/2006 5:31:52 PM
how do i test the cam angle sensor to see if it is bad?
EMonz57
5/6/2006 7:24:45 PM
did you hook the wires into the correct coils? there are 2 coils correct?? on controlls 2 cyl and the other controlls the other 2. If you hooked the wrong cyl into the wrong pack maybe?? I dunno.
xslim69
5/8/2006 7:05:49 PM
the wires are hooked up right and the coils been replaced. i have no fuel supply and no speark. i re placer the injector resistor pack and the power transister unit. the car ran fine for about 3 days and than died in a quick chek parking lot. i am really cofused cause i never seen this problem with any car before. question would the cas control spark and fuel?
xslim69
5/8/2006 7:09:46 PM
and also could a ****ed up turbo cause thes problems
