Sanguinius
11/21/2007 4:15:13 PM
Well after a full year of being down and various problems creeping up on me, the 88 Conquest TSi is back on the road and making GOOD power! Hopefuly next time I get to go to the track I'll be making somewhere in the 12's. Yes I'm being conservative and the next thing to do to the car is take her to the dyno. I'll post the scan of that when I finally do.
For those that don't know here's a quick run-down of what she's packin now:
G54B block
Bored .020 over
Shot peened, lightened and race prepped rods
Clevite bearings
Polished crank
Balance shaft's eliminated
Wiseco .020 over 8.0:1 forged pistons
Clearwater head casting
1MM oversized valves
5 angle valve job
port/polished
throttlebody and intake bored to 56MM (42 is stock)
mechanical lifters
100# Schnieder valve springs
ARP head studs and conn rod bolts
14G turbo
3" turbo back catless exhaust
ACT clutch
I think I covered the engine work I did. A few setbacks and an uncooperative ignition system but finally she's running much better. Though if I set the timing via the light she runs like poo... Still trying to figure that one out.
dsm1990gsx
11/21/2007 5:53:37 PM
Post some pics of everything you did. Do you have any videos?
Sanguinius
11/21/2007 6:41:18 PM
Not yet still tryin to get the bugs worked out. Once I do I'll take some vids and start posting pics :D
nick_200321
11/21/2007 7:50:27 PM
.. .. .. . i wanna see pics... you dont need mechanical bugs to be fixed for pics :D
slow420a
11/22/2007 8:23:26 AM
Damn, I remember when you first got that thing... Its had to of been a tough time waiting to get her running right, I wouldn't have had the patience lol. Definatly post of pic tho.
jpmontero98
11/22/2007 1:25:44 PM
sweet pics are much needed....
