So i threw a SES light a couple days ago in the. The roads were ****ty and parking lots were icy, so as you could imagine...i had a little fun. The last donut resulted in a stall out. I had to crank it for a few seconds before it started, and when it did the SES light was on and it idled like sh1t for a minute. The car ran fine after the brief dump the idle took. I pulled teh codes today before work and cleared them.
P0340
Camshaft Position
Sensor A - Bank 1
Circuit Malfunction
P0335
Crankshaft Position
Sensor A
Circuit malfunction
I suspect the o2 sensor was flooded, and the start up problem from the misfire. Anything i should be worried about, since i don't usually worry until a SES light comes back?
stutinr1
1/8/2008 3:58:08 PM
hey im new here but same **** went on
my car
I changed the plugs
one has fried
