RE: Car Shudders While Accelerating or Climbing Hills

Mitsubishi Forum Classifieds Photo Gallery Timeslips Member List Search Sponsors Contact MF
Mitsubishi Lineup Mitsubishi News Recalls TSBs Timeslips Calendars Register Login

RE: Car Shudders While Accelerating or Climbing Hills - Only at Highway Speed...

Printable Version

Mitsubishi Forums >> Tech Help and Information >> Everything else >> RE: Car Shudders While Accelerating or Climbing Hills - Only at Highway Speed...

Page: << < prev 1 [2]

Message

<< Older Topic Newer Topic >>

RE: Car Shudders While Accelerating or Climbing Hills -... - 12/22/2006 10:41:43 PM

SDRaymond

Posts: 7
Joined: 8/31/2004
From: Wisconsin
Status: offline

I'm going to have it done next week and will post the results. Will driving it in this condition cause damage to the transaxle or is it just annoying?

Thanks again, you been incredibly helpful!!

Hope You and Your Family have a Happy and Safe Holiday!

Scott

(in reply to Manybrews)

Post #: 11

RE: Car Shudders While Accelerating or Climbing Hills -... - 12/22/2006 10:46:04 PM

Sebba

Posts: 14756
Joined: 2/20/2006
From: San Antonio, TX
Status: offline

Manybrews your awesome.

_____________________________

These cranks are made for walkin'''', and thats just what they''''ll do, one of these days these cranks are gonna walk all over you

(in reply to SDRaymond)

Post #: 12

RE: Car Shudders While Accelerating or Climbing Hills -... - 12/23/2006 9:47:30 AM

Manybrews

Posts: 816
Joined: 5/23/2003
From: United States
Status: offline

quote:

ORIGINAL: SDRaymond

I'm going to have it done next week and will post the results. Will driving it in this condition cause damage to the transaxle or is it just annoying?

Thanks again, you been incredibly helpful!!

Hope You and Your Family have a Happy and Safe Holiday!

Scott

it shouldnt.

as I said though, if its bad enough a flush MAY not take care of it. I havent had one yet that needed a new torque converter, but its possible.

(in reply to SDRaymond)

Post #: 13

RE: Car Shudders While Accelerating or Climbing Hills -... - 12/24/2006 5:01:20 PM

mxmikie

Posts: 228
Joined: 9/6/2005
Status: offline

i had a bad cv that would only shudder under a load hills or passing

(in reply to Manybrews)

Post #: 14

RE: Car Shudders While Accelerating or Climbing Hills -... - 12/31/2006 2:45:14 PM

SDRaymond

Posts: 7
Joined: 8/31/2004
From: Wisconsin
Status: offline

Well Gents, as of yesterday, I'm a Happy Camper!!

I scheduled a transaxle flush and fill for last Wednesday 12/27. When I arrived, the Service Manager informed me that they didn't have the equipment to complete a flush, they were just going to change the fluid. Well, I had done that the week before, so I said "no thanks"...

I decided to check out the CV Joints as recommended. THANKS!! The inner CV Joint on the RH CV Shaft had a 1/2" slit in it. I ordered a replacement shaft assembly manufactured by EMPI, all new parts, not re-manufactured. The project was "less than fun", but my car is running smooth again!

Thanks for all the input everybody!!

Be Safe and Have a Happy New Year!

Scott

(in reply to mxmikie)

Post #: 15

RE: Car shudder 2001 Mitsubishi Eclipse V6 GT - 2/1/2007 6:51:46 AM

spyder@JV

Posts: 1
Joined: 2/1/2007
Status: offline

Hello,

I have a 2001 Mitsubishi Eclipse V6 GT and the same symptoms, but since I am stationed overseas I would need some help and info.

(Manybrews could you help me here). I would need the complete 3 Pages of the shown TSB-03-23-006 to show my mechanic what to do since they dont know car over here.

The bad thing: I had the car serviced in Ft Hood ( got a 60k service at 50K to be sure all is done (Timing belt etc)before I came over here last year, but the mechanic there only put half of the trans fluid in there as I found out.)So this led to transmission slips when driving around corners. And I am sure didn't help in the overall picture (heat. lack of lubrication) and I paid $1300 for a crappy job, so dealer there took advantage of me.

So correct me if I am wrong. to get rid of shudder, first thing is to flush, then use SPIII (although this didn't helpe here), if not gone then replace torque converter, correct ???

If so, could somebody provide me the complete TSB 3 Pages and tell me the exact part # of the torque converter and approx price.

Since being stationed overseas and handling car issues, in a country where there are no parts available is no fun.

Thank you very much !

Take care.

JV

(in reply to SDRaymond)

Post #: 16