Intake for 06
Login  | |
|
Intake for 06 - 2/19/2007 4:21:23 PM
|
|
|
06OutlanderSE
Posts: 313
Joined: 7/5/2006
Status: offline
|
Does anyone know any intakes that fit the 06 outlander...with mivec....i was looking at some ralliart intakes bc its the same engine but not sure if any of the cold air ones will fit......i am pretty sure the short ram ones will?
|
|
|
|
|
|
|
RE: Intake for 06 - 2/19/2007 7:31:57 PM
|
|
|
expositor
Posts: 119
Joined: 6/14/2006
Status: offline
|
hey o6,
nice pic's by the way, like the others you posted last year - that evo of yours was nice!
did you check road race motorsports' site? they offer a ralliart short-ram for the lancer 2.4 mivec like in our outlanders, though it uses a 90-degree elbow to put the air cleaner between the battery and the exhaust manifold where it'll be closer to heat, and close to the radiator where you'll be forced to dispense with the ram air tube. i bought a weapon-r, but it was made for an outlander with the old honeycomb maf sensor, not the probe type like my '06 had; you might remember my post of last september or so when i described the efforts in getting it to fit....if you have the older type maf, the weapon-r will definitely fit, and quite easily. short of that, i noticed amazon.com sells intake tubing, which might be an economical way to a simple intake, to which you could add one of those new dry cone filters by, i believe, aem. other than going to a speed shop where they'll allow you to physically see if a given eclipse 2.4 intake will fit, the options are very limited for us outlander owners, especially since the new outlander has replaced ours in the marketplace....
|
|
|
|
|
Printable Version
