|
chili_g -> RE: Dash kits for 07+ (7/23/2007 4:59:25 PM)
|
I think the wood grain etc. is all really thin stuff to apply over a solid surface.
I don't think hacking the non-nav face plate will leave you with a clean shaped surround. If you look close, the gap between the hole and the hazard button looks different. I'm not sure though... you could try it.
I lost patience and just bit the bullet and bought a OEM nav faceplate. Chewed me for $150 - not to mention I only have a single din head unit anyway. I will make a fill plate similar to what Zontarh posted above, until someone comes out with a double din that I like (kenwood is close, but the USB port is on the front. Duh.)
I wouldn't hold your breath on an aftermarket kit anytime soon. They will have to incorporate the seatbelt/airbag warning light lenses as well as the hazard flasher button. Neither of the two big kit makers have plans (per website, and I emailed one of them). Kind of bites.
On the bright side... this forum has figured out the wiring you need, since there aren't any wiring harnesses ;)
BTW, whatever you do, you need the little circuit board with the hazard button on it and airbag lights. You will have a constant service warning without it plugged in (airbag).
|
|
|
|
