intercooler piping (Full Version)

Mitsubishi Forums >> Mitsubishi Models >> Mitsubishi Evolution

intercooler piping

  

southside -> intercooler piping (2/6/2008 8:23:18 PM)

is injen a good company for intercooler piping for stock psi or should i good with somthing else.

  
TheEngineer -> RE: intercooler piping (2/7/2008 4:13:27 AM)

Injen i believe is fine for a stock system. I think as you look for more power it will become someone of a restriction just because of the design. Emonz actually has it on his 400+ evo and i think he was gonna be changing them out for something better. But for a stock turbo and boost they wont be a problem

EMonz57 -> RE: intercooler piping (2/7/2008 5:12:44 AM)

they are not bad BUT I would go with ETS pipeing kits if I could start all over again because they look alot better and routed better

Rob -> RE: intercooler piping (2/7/2008 3:57:41 PM)

I'll be going with the buschur piece and a small battery kit, myself.

5280LANEVO -> RE: intercooler piping (2/7/2008 4:12:36 PM)

Is a hard pipe kit that much better or should one just get a whole FMIC kit? more like is it worth it to get a hard pipe kit.

EMonz57 -> RE: intercooler piping (2/7/2008 4:20:24 PM)

depends on your mods.   IMO the pipeong it is more for looks than anything.   But there is also no need for a FMIC if your on the stock turbo in most cases.   that asside with a piping kit you can alway use a different FMIC at a later time it takes very little to make them fit from the stocker IC to a aftermarket one.   For example I was running the injen on my stock IC and now I have all these mods and a new FMIC and still running the injen up pipe

5280LANEVO -> RE: intercooler piping (2/7/2008 4:28:30 PM)

What's a good hard pipe kit? does HKS make one.

EMonz57 -> RE: intercooler piping (2/7/2008 4:56:12 PM)

quote:

ORIGINAL: 5280LANEVO

What's a good hard pipe kit? does HKS make one.

ETS
Buschur racing
AMS

all of those will be just as good or better than HKS and cheaper in most cases.

southside -> RE: intercooler piping (2/7/2008 6:49:20 PM)

thanks what i was going to get was the ams kit but hearing about the mts, its sounds better. but i look more in to it, if i was going to make my own, what kind of materials should i use for better performance and looks.

5280LANEVO -> RE: intercooler piping (2/8/2008 3:03:34 PM)

2.5 or 3" aluminum pipeing also get T-bolt clamps others seem blow off all the time.I used Vibrent universal pipe kit on my 240 and loved it.

  

Page: [1] 2 3   next >   >>

Return to Mitsubishi Forum home page or view the Full Version of this page.