Starter Grind (Full Version)

Mitsubishi Forums >> Mitsubishi Models >> Mitsubishi Mirage

Starter Grind

  

2nejunkie -> Starter Grind (6/4/2008 5:31:18 PM)

Hello All.

After I installed the new engine in the 99 Mirage 1.5 Auto. I reused the old starter and now it sounds like it needs a spacer. So I add space, still sounds like its grinding.

I bought brand new starter to get the same results, Im stuck here. I have tried spacers and no spacers.


  
Sebba -> RE: Starter Grind (6/4/2008 6:01:10 PM)

Is the starter grinding after you let go of the key?

2nejunkie -> RE: Starter Grind (6/4/2008 8:03:33 PM)

while im turning the key.
I think I may have just figured out where maybe I went wrong on the motor install.
The TQ conv. is attached to the flywheel and then theres a Plate that attaches to the motor and then to the TQ conv.

Is it possible this Plate is reversed?


2nejunkie -> RE: Starter Grind (6/7/2008 4:05:03 PM)

Ok now I am confused.

I took the motor back out to switch driveplate but now it wont let the trans be mounted.

The question now is Does the spacer go between the crank and the driveplate or the driveplate and the torque converter?
I will take a picture so ya''''ll cann see what Im looking at.
[image]http://i298.photobucket.com/albums/mm270/2nejunkie/driveplate.jpg[/image][image]http://i298.photobucket.com/albums/mm270/2nejunkie/spacer.jpg[/image]
Driveplate                                             Driveplate/TQ Converter spacer?

  

Page: [1]

Return to Mitsubishi Forum home page or view the Full Version of this page.