not firing on cylinders 2 and 3 (Full Version)

Mitsubishi Forum >> Tech Help and Information >> Everything else

not firing on cylinders 2 and 3

  

macrader1 -> not firing on cylinders 2 and 3 (6/19/2008 7:52:39 PM)

i just bought the car tonite. with known problems. its a 1997 mitsubishi eclipse spyder gs-t. the motor has been swapped in the car. not sure exactly what it is maybe someone can figure out by the pics. im only getting spark on cylinders 1 and 4 though. car runs but runs really really rough. anybody have any ideas? i was told to check the coil pack, which i will be replacing tomorrow. other than that any other things that would cause this problem? im also not sure which coil pack to get. i went to autozones website and coulnt find one that looked anything like it.


[image]local://upfiles/17348/0A340951EC684C73BF8E4C2F9A8A1A90.jpg[/image]

[image]local://upfiles/17348/0873F6F2DBAB415B8E3698F4651438DB.jpg[/image]

  
macrader1 -> RE: not firing on cylinders 2 and 3 (6/19/2008 7:53:45 PM)

on the plus side i only paid 2400 for the car

Sebba -> RE: not firing on cylinders 2 and 3 (6/20/2008 9:08:23 PM)

If the car runs at all, that means you must be getting some spark, because the car cant run on even 3 cylinders.

CONFIRM that they aren''t firing... because that makes no sense.

If its running ****ty, check the timing, check/replace spark plugs and wires.

macrader1 -> RE: not firing on cylinders 2 and 3 (6/20/2008 9:25:03 PM)

cam postion sensor maybe....its not even there. there is however a removable rubber plug where the sensor goes. it seems like the car is going into some kind of weird mode. it will start the first time firing only on cylinders 1 and 4 but if it dies i have to disconnect the battery in order to get it to start back up.

  

Page: [1]

Return to Mitsubishi Forum home page or view the Full Version of this page.