1995 gst wont start! after timing belt replacement

Printable Version

Mitsubishi >> Tech Help and Information >> Everything else >> 1995 gst wont start! after timing belt replacement

Page: [1]

Login Message << Older Topic   Newer Topic >>

1995 gst wont start! after timing belt replacement - 9/30/2005 9:22:27 PM    Jeffb1   Posts: 9 Joined: 9/30/2005 Status: offline I swaped out the timing belt today and while i was doing so I broke the cam position sensor. I did not know it untill I put the car back together and it would not start. I was in a rush to get it back together and may not have alligned the timing right. I guess what I need to know is, if the cam sensor is broken should the car still start? If it should start then I will know the reason it wont is becuase of the timing. Is the broken sensor causing the car not to start or should I go back and make sure the timing is right? I lined up the marks on the cam gears but I am not sure if the cams are lined up in relation to the crank. I dont know if the #1 piston was at tdc when I put it back together. Any help is appreciated! Jeff < Message edited by Jeffb1 -- 9/30/2005 9:27:28 PM > Post #: 1

RE: 1995 gst wont start! after timing belt replacement - 10/1/2005 9:58:22 AM    shreff99 Posts: 1204 Joined: 9/22/2005 From: Franklin, PA Status: offline I had a '97 Eclipse Spyder with the 2.4L engine and the balance shaft belt broke and burnt out my cam sensor and it wouldn't fire back up...I had to have it towed to the garage...So it is a possibility that the broken cam sensor could be causing the starting problem...It's always the electrical **** that gives you the biggest problems...Is the "check engine" light on? _____________________________ 1999 Eclipse GS-T..Some mods and a lot more to come..Pimpin'' Ain''t Easy, but it''s necessary. (in reply to Jeffb1) Post #: 2

RE: 1995 gst wont start! after timing belt replacement - 10/1/2005 12:46:53 PM    Jeffb1   Posts: 9 Joined: 9/30/2005 Status: offline It has to start to know if the check engine light is going to come on. Man this sucks. The worst part is, this is my brothers car, and he is pissed. The cam sensor is an $80 part. Is it possible that the system just needs to be reset by mitsubishi? I had the battery disconnected for a while, while we hooked up a radio. I wish i knew more about these electrical systems. Jeff < Message edited by Jeffb1 -- 10/1/2005 1:01:16 PM > (in reply to shreff99) Post #: 3

RE: 1995 gst wont start! after timing belt replacement - 10/1/2005 2:43:56 PM    Joel_CA   Posts: 472 Joined: 9/20/2005 Status: offline The cam sensor is a vital component to the ignition system and will cause a no start. You can quickly take the top of the timing belt cover off to check if the timing belt is lined up properly as you replace it. As far as reseting goes- the PCM does adapt and learn values such as fuel trim or idle setting, etc. It does NOT learn anything that can prevent the engine from firing up. Good Luck! Joel, CA < Message edited by Joel_CA -- 10/1/2005 2:47:14 PM > _____________________________ 1992 3000GT VR4 & 1996 STEALTH RT/TT #47 *both tastefully modded* (in reply to Jeffb1) Post #: 4

RE: 1995 gst wont start! after timing belt replacement - 10/1/2005 5:43:16 PM    Jeffb1   Posts: 9 Joined: 9/30/2005 Status: offline Well I guess i need to replace the sensor. I just got it all put together and now i have to take it all apart again. what a pain in the ass. Thanks for the info!! Jeff (in reply to Joel_CA) Post #: 5

RE: 1995 gst wont start! after timing belt replacement - 10/1/2005 10:58:58 PM    Jeffb1   Posts: 9 Joined: 9/30/2005 Status: offline I was just loking on napaautoparts.com and they have two different cam sensors listed. One is an engine management cam sensor, and the other is an ignition cam sensor. They both look the same to me. Does anyone know which one I need? The one I broke is located inside the intake cam. They look the same but there is almost a $30 difference in the prices. I dont want to buy the wrong sensor and have to do this again later. Jeff < Message edited by Jeffb1 -- 10/1/2005 11:01:20 PM > (in reply to Jeffb1) Post #: 6

RE: 1995 gst wont start! after timing belt replacement - 10/3/2005 11:54:37 AM    shreff99 Posts: 1204 Joined: 9/22/2005 From: Franklin, PA Status: offline Just pull the broken sensor off and take it with you to the parts store so they can see which one it is. _____________________________ 1999 Eclipse GS-T..Some mods and a lot more to come..Pimpin'' Ain''t Easy, but it''s necessary. (in reply to Jeffb1) Post #: 7

RE: 1995 gst wont start! after timing belt replacement - 10/3/2005 12:44:54 PM    Jeffb1   Posts: 9 Joined: 9/30/2005 Status: offline we'll I as going to buy it online but it looks like mitsubishi is going to be cheaper anyway. So I will just go up there and get it. Thanks for all the help! Jeff < Message edited by Jeffb1 -- 10/3/2005 1:02:12 PM > (in reply to shreff99) Post #: 8

Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds

Mitsubishi Prices

Mitsubishi Vehicles
3000GT Lancer
Diamante Zinger
Eclipse Outlander
Endeavor Raider
Galant Lancer Evo

Top 10 Posters
sebba 14725 emonz57 11693 theengineer 10743 rcjr9186 5638 sanguinius 4762 dusty eclips 4387 jpmontero98 3431 silvercoupe9 3420 davidmitsusr 3360 dsm1990gsx 2959

New Vendors
AMSOIL - Performance Oil Technology