added rca outputs to my stock infinity amp

Mitsubishi Forum Classifieds Photo Gallery Timeslips Member List Search Sponsors Contact MF
Mitsubishi Lineup Mitsubishi News Recalls TSBs Timeslips Calendars Register Login

added rca outputs to my stock infinity amp

Printable Version

Mitsubishi Forum >> Show Time >> Audio/Visual Electronics >> added rca outputs to my stock infinity amp

Page: [1]

Message

<< Older Topic Newer Topic >>

added rca outputs to my stock infinity amp - 1/17/2006 11:13:28 PM

noremacyug

Posts: 3
Joined: 1/16/2006
Status: offline

alright, after deciding to put the sub i pulled out of my truck into my 00 eclipse i was determined to have rca jacks and to have an actual remote on/off to turn my amp on/off with the radio and not when the ignition is turned on. so, i ripped out my seat and pulled the amp out and then tore into the amp. i then simply soldered some rca ends onto the circuit board where the din cable connector comes in. i also soldered a wire to the remote wire pin from the din cable connector which gives me a 6v signal on that wire. im going to use that 6v to hook up a low voltage trigger that will give me the 12v i ned for the remote wire hookup on my aftermarket amp. i got it all hooked up and temporarily applied 12v right from the battery to the remote hookup to test everything out. it all works perfect. i put the sub onto the rear channels and so far im happy with the results and the fact that i can keep my stock stuff while having the much needed bass from the sub.

Thumbnail Image