Mitsubishi Forums Mitsubishi Forums    
   
Mitsubishi
Mitsubishi Forum   Classifieds   Photo Gallery   Timeslips   Member List   Search   Sponsors   Contact MF
  Mitsubishi Lineup   Mitsubishi News   Recalls   TSBs   Timeslips   Calendars   Register   Login  

need help!!!!

  Printable Version
Mitsubishi Forums >> Tech Help and Information >> Everything else >> need help!!!! Page: [1]
Login
Message << Older Topic   Newer Topic >>
need help!!!! - 4/30/2006 8:08:00 PM   
xslim69

 

Posts: 39
Joined: 4/23/2006
Status: offline
i have a 1997 gst. the problem im having is it wont start. i have tested all the sensers and their ok. i get spark on all 4 but no fuel in to the clienders. i have replaced the ecu,coil packs,fuel filter,plugs,wires. the injectors are not pulsing, but the fuel pump comes on.
could the injestor resistor pack be bad.
Post #: 1
RE: need help!!!! - 5/1/2006 8:26:29 AM   
slow420a



Posts: 2327
Joined: 8/8/2005
Status: offline
Thats possible or you could have a bad cam position sensor.

_____________________________


(in reply to xslim69)
Post #: 2
RE: need help!!!! - 5/1/2006 3:45:46 PM   
xslim69

 

Posts: 39
Joined: 4/23/2006
Status: offline
i just found out today that my 97 gst has a 1g motor in it. the can angle is good. that is one of the many things i tested, it has power and is sending signal to the ecm. this all happened when i upgrated the plugs and wires.

(in reply to slow420a)
Post #: 3
RE: need help!!!! - 5/6/2006 5:31:52 PM   
xslim69

 

Posts: 39
Joined: 4/23/2006
Status: offline
how do i test the cam angle sensor to see if it is bad?

(in reply to xslim69)
Post #: 4
RE: need help!!!! - 5/6/2006 7:24:45 PM   
EMonz57



Posts: 11693
Joined: 5/13/2005
Status: offline
EMonz57's photo gallery
did you hook the wires into the correct coils? there are 2 coils correct?? on controlls 2 cyl and the other controlls the other 2. If you hooked the wrong cyl into the wrong pack maybe?? I dunno.

_____________________________

1993 Supra 6spd(OOOO\ ..... /OOOO)

(in reply to xslim69)
Post #: 5
RE: need help!!!! - 5/8/2006 7:05:49 PM   
xslim69

 

Posts: 39
Joined: 4/23/2006
Status: offline
the wires are hooked up right and the coils been replaced. i have no fuel supply and no speark. i re placer the injector resistor pack and the power transister unit. the car ran fine for about 3 days and than died in a quick chek parking lot. i am really cofused cause i never seen this problem with any car before. question would the cas control spark and fuel?

(in reply to EMonz57)
Post #: 6
RE: need help!!!! - 5/8/2006 7:09:46 PM   
xslim69

 

Posts: 39
Joined: 4/23/2006
Status: offline
and also could a ****ed up turbo cause thes problems

(in reply to xslim69)
Post #: 7
Login OR Register now to post a reply to this forum topic.
Page:   [1]

 
Mitsubishi Forums >> Tech Help and Information >> Everything else
Jump to:



Featured Sponsors
Advertising Info

Top 10 Posters
sebba14725
emonz5711693
theengineer10734
rcjr91865638
sanguinius4762
dusty eclips4387
jpmontero983425
silvercoupe93409
davidmitsusr3360
dsm1990gsx2954

New Vendors
AMSOIL - Performance Oil Technology

Mitsubishi Forum .com is not affiliated with or endorsed by Mitsubishi Motors.